Play pink, white or brown noise
Lower the output volume before starting. Choose five seconds, 30 seconds or continuous playback, then select a noise color.
Playback length changes this player only. Download fixed 10-second WAVs or MP3s.
Ready. Start with pink noise at a low hardware volume.
No microphone, recording or spectrum analysis. Continuous mode stops when you press Stop, leave the page or hide the tab. These are not calibrated noise levels or sleep tracks.
Quick answer: lower the hardware volume, choose 5 seconds, 30 seconds or continuous playback, then start one noise color. Continuous mode remains active only while this tab is visible and stops immediately when requested. This page generates sound; it does not listen to the room, measure frequency response or calibrate speakers.
How long can the noise generator play?
Five-second mode is the default for a quick output check. Thirty-second mode supports a longer comparison. Continuous mode loops a locally generated ten-second buffer until you press Stop, leave the page or hide the tab. It does not run as an unattended sleep track, collect microphone input or claim a focus, therapy or hearing benefit.
Download 10-second noise samples
Choose WAV for the original 16-bit PCM sample or MP3 for a smaller copy of the same recording. Both formats use fixed 10-second samples with short fades, independent of the player settings.
Pink noise
Filtered random signal with progressively less energy toward higher frequencies.
White noise
Random signal with approximately equal power per unit of frequency.
Brown noise
Integrated random signal with stronger low-frequency emphasis.
Return to noise playback to choose a different playback length.
The original WAV samples have a digital peak ceiling of 3% of full scale. Start at a low volume. Amplifiers, speakers, headphones and system processing determine the sound level that reaches a listener.
What changes between pink, white and brown noise?
Pink noise
The filter reduces energy toward higher frequencies, producing a more octave-balanced comparison than white noise. This implementation is a practical browser and file signal, not a laboratory reference.
White noise
The random samples have approximately equal power per unit of frequency. It often sounds brighter because wider high-frequency bands contain more energy.
Brown noise
The random signal is integrated so energy is weighted more strongly toward lower frequencies. It can sound much darker and does not mean the output has stronger bass response.
Are the noise samples repeatable?
The live generator uses a fixed seed for each noise color, making its sequence repeatable under the same playback settings. Sample rate, duration, output device and processing can affect what you hear. The downloadable WAVs are separate files.
How to use noise for a basic speaker comparison
- Select the intended speaker, headphone or receiver output and lower its hardware volume.
- Play pink noise once. Confirm that audio comes from the intended route and stop if it is harsh, uncomfortable or distorted.
- Keep the same volume and position if comparing another output or noise color. Change only one variable at a time.
- Use the downloadable files when the target device has no suitable browser.
- Confirm suspected problems with familiar audio and the equipment maker's test or service instructions.
What this page can and cannot tell you
A short noise sample can confirm that the selected route plays, provide a repeatable broad-spectrum stimulus and help you compare whether a rattle or interruption repeats. It cannot separate a speaker, room, amplifier, crossover, equalizer, codec, listener or hearing effect.
The output is mono. Use the speaker and sound test for left/right routing, the frequency sweep generator for a changing sine frequency, the DTMF tone generator for the paired tones of a phone keypad, or the 5.1 surround test for a browser-reported six-channel route. A mono signal on a wired stereo pair that sounds thin in the middle can point to reversed polarity, which the phase test for stereo speakers checks directly. For built-in laptop speakers, start with the laptop speaker test. If a phone speaker sounds muffled after recent liquid exposure, noise playback will not help; use the wet-phone guide instead.